INDICATIONS AND CHARACTERISTICS
- For cement and concrete floors: factories, garages, terraces, etc.
- Great chemical and mechanical resistance. High adherence.
- NON INFLAMABLE product.
- Application supports must be porous.

PREPARATION
It is recommended to apply two coats,diluted with water in the following proportion: 30%-40% for the first coat (3 or 4 litres of water per 10 Kgs. of paint). It is recommended not to thin the second coat.

APPLICATION
It has to be applied with wool roller, brush or pressure equipment. The support must be hard and ABSORBENT. If concrete is bright or shows mould and salpeter stains, it is recommended to open the pore and remove the old layer by washing it with water.
It is recommended to apply one coat of FIXAMUR on dusty surfaces.

SPREADING RATE
Approximately 4,0-10,0 m2/Kg. appliying one coat depending on the rugosity and the surface. A standard spreading rate is 2,5-3 m2/Kg. appliying two coats with a wool roller.

TECHNICAL CHARACTERISTICS
Nature : Acrylic resins.
Pigment : Titanium dioxide.
Density : 1,46 gr./cm3.
Thinner : Water.
Drying time (in normal conditions) 
- to touch : 40 minutes.
- recoating interval : 4 hours.
- for chemical attacks : 5-6 days.
- fully dry : 28 days.
Viscosity : 330 Poises.
Toxicity : It does not contain arsenics, mercury, silver or plumb.
Do not use by temperatures below 5º C.

NOTE: The data reflected here is informative and  agree with the rehearsals carried out in our Laboratories under good conditions of application. If these suffer a change they would be carried out a previous rehearsal again.