USES AND CHARACTERISTICS
One component enamel to paint galvanized iron on exterior and interior surfaces. 
Very good protection against the rust. 
Excellent adherence on galvanized. 
Very good coverage. 
Quick drying. 
It does not contain plumb pigments, chrome and phosphoric acids. 
Do not degrade the galvanized. 
PREPARATION AND APPLICATION
Preparation of surface : Apply on dry and clean surfaces. 
New galvanized iron : The galvanized must be taken the grease out of, apply one or two coats of Galvodur Acabado. 
If you want a different colour, finish with synthetic enamel SEDALUX Alto Brillo or SEDALUX Satinado with polyurethane. 
Old galvanized iron : eliminate the rust and the old paint bad adhered with sandpaper or remover. When it is clean proceed as new galvanized iron. 
Conditions of application : a good stirring of the product before use. 
Temperature between 5 and 40º C. Relative humidity 85%. 
Tools application : Brush, roller, spray-gun, airless gun. 
Thinner:                  160.0920         160.0920       160.0920 
Dilution :                     0-5%             10-15%           5-10% 
Clean tools with Universal Thinner. 

SPREADING RATE
Approximately between 10 and 14 mt2/ litre. 

COLOURS
Only white. 

TECHNICAL CHARACTERISTICS
Gloss : Semi-mat. 
Solids Volume Rate : 48%. 
Density : 1'3 Kg./litre. 
Drying time at 20º C. and 65% R.H. 
Without stickiness : 4-5 hours. 
Recoating interval : 24 hours. 
Resistance continuous temperature : 90º C. (dry heat). 

NOTE: The data reflected here is informative and agree with the rehearsals carried out in our Laboratories under good conditions  of application. If these suffer a change they would be carried out a previous rehearsal again.