INDICATIONS AND CHARACTERISTICS 
- Transparent primming. 
- Odourless. 
- Easy application. 
- Satiny finish. 
- Quick drying. 
- Pellicle elastic and flexible. 
- High strength sealer. 
- Specially indicated for sealing interior surfaces (plaster, cement, brickwork, pasteboard, etc.) that go to paint with plastic paint. To strengthen a weak paints, as protector transparent varnish and to glue of paper, cardboard, wood, etc. 

PREPARATION AND APPLICATION 
Apply over clean and dry surfaces. It is necessary to clean grease, dusty, etc. 
Dilute 1 part of LATEX with 4-6 parts of water depending on the absorption of the surface. 
To strengthen a distemper paints or glue should be added 10%. 
As protector transparent varnish, apply  the first coat being diluted with 1 part of latex and 6 of water, and the second diluted with 1 part of latex and 4 of water. 
As adhesive of glued, it can be used no diluted or little diluted if the materials to glue are very absorbents. 
Do not use by temperatures below 5°C with a relative humidity will of 85%. 
To apply with a roller or brush. 

SPREADING RATE 
Approximately 6-10 mt2/l, depending on dilution and absorption of the surface. 

COLOURS 
Transparent, when it is dry.

POT LIFE 
36 months since production, in original tin, do not open, store in a dry place with temperatures between 5°C and 35ºC. 

TECHNICAL CHARACTERISTICS 
Density : 1Kg/lt. Approximately. 
Solids volume ratio : 39,5%. 
Drying time (in normal conditions) 
- to touch : 1 hour, depending on dilution and surface. 
- recoating interval : 5-6 hours is ready to paint. 
Clean tools : Water. 
Thinner : Water. 
Gloss : Satiny. 

NOTE: The data reflected here is informative and agree with the rehearsals carried out in our  Laboratories under good conditions of application. If these suffer a change they would be carried out a previous rehearsal again.